Yes. This variant is a 6-pack of stainless steel 0.9 mm plates with a matching set of wood screws included, so you have the hardware to install them straight away. The screws are designed for wood and wood-based furniture panels.

It is a flat, trapezoid triangle gusset plate (about 62×19 mm, 0.9 mm thick) with five countersunk holes and gently shaped ends. It sits flat across the joint face to reinforce the corner — it is not a three-sided wraparound bracket, so please check the dimensions against your project before ordering.

Stainless steel resists rust and handles normal indoor humidity better than ordinary painted steel, so it is suitable for kitchen and bathroom cabinets. It is intended for indoor furniture rather than permanent outdoor, rain-soaked or saltwater exposure, where a marine-grade fitting would be needed.

We recommend shallow pilot holes, especially near board edges or in hardwood and particleboard, to prevent splitting and help the screws pull tight. Keep the joint square and drive each screw until the head sits flush; do not over-torque in brittle board material.

There is no single load rating — strength depends on the wood, screw length, and how many plates and screws are used. These 0.9 mm plates are made for reinforcing everyday furniture joints, not as the sole support for heavy overhead loads, safety barriers, or structural building work; size up or use a heavier bracket for demanding loads.